EZ-STIK Trowelable Sealant

EZ-Stik #3 is a trowelable butyl sealant suitable for pumping or trowel dispensing onto concrete structures.

Category: Butyl Sealants, Lubricants and Wraps

General Details
Installation
Documents

Document Downloads

EZ-STIK’s butyl sealant is primarily used as a backplaster on manhole and box culvert joints and as an external manhole chimney seal. It can be used as a primary or secondary flexible seal that bonds to a wide variety of materials. The physical properties of the sealant resists temperature extremes, acids and alkalis.

How It Works

Clean and dry surface.
Apply and smooth with a clean edge trowel blade at 1⁄4” minimum thickness.
If using in water collection system, do not backfill immediately.

Why It's Better

High-quality butyl rubber base.
Excellent gap and crack filling properties.
Resistance to acids and alkalis.
All-weather protection.
A permanent flexible solution.

Where To Use

Concrete joint repair
Sanitary Manhole Joints
Stormwater Manhole Joints
Irrigation and Drainage Systems
Box Culverts
Elliptical/Arch Pipe
Architectural Foundations
Concrete crack repair
Underground Utility Vaults
Stormwater Treatment & Inlet Structures
On-Site Treatment Tanks
Grease Interceptors
Wet Wells

TROWELABLE EZ-STIK #3 is available in 5 gallon pails or in cartons of 12 – 11 ounce caulking tubes.

Meets or Exceeds

This sealant meets or exceeds:

Federal Specification TT-S-001657 for Solvent Release Butyl Sealants

Caution

Must ship via truck freight due to flammability.

INSTALLATION INSTRUCTIONS FOR TROWELABLE #3 EZ-STIK AS A PROTECTIVE COATING

Clean and dry the concrete surface to which the sealant will be applied. Remove any dirt and/or mud adhering to the surface.The surface must be dry for the sealant to adhere and bond to the concrete. #4 EZ Primer can be applied to the surface to increase adhesion of the #3 EZ-STIK
The sealant should be applied with a smooth-edge trowel. Then it should be applied a minimum of 1/4” thick. The surface to be protected must be totally covered with no surface showing through the sealant. Coverage is 7 square feet per gallon when applied 1/4” thick.
When using this sealant as an external chimney seal (Butyl Rubber Backplaster), apply it 6” from below the top cone to the casting. Then it should be applied 1/4” thick with a smooth-edge trowel. After coating the chimney, with the sealant, wrap the applied #3 EZ-STIK with a 6mm polyethylene plastic sheeting by Visqueen or approved equal. Wait 20 minutes before back-filling.
The structure should not be back-filled for a minimum of 20 minutes after coating with the sealant. This allows the solvents to dispense throughout the #3 EZ-STIK.